|
e.Commander
** IMPORTANT NOTE **
There are two different versions of e.commander
depending on what version of V3 e.gate firmware you are using (ONLY
applies to V3 e.gates).
Firmware V1.09 OR PRIOR
Version 1.4.2 B02 Setup EXE File
Also, if your e.gate / e.pac is using V1.06 to
V1.09 firmware you should update to V1.09c to prevent possible
intermittent failure issues:
Version
1.09c Firmware ZIP File
*** Please Read ***
Although it is possible to revert a V1.10 e.gate
to a V1.09, this procedure is non-standard and a bit
complicated. Please contact ioSelect directly for more
information.
Firmware V1.10 OR GREATER
Version 1.4.4 B03 Setup EXE File
Both versions can be installed on the same PC at
the same time for legacy support. Make sure you install to
different directories.
Also, V1.10 firmware introduces some changes in
the UDP data packet structure that MAY effect some
software drivers. For more information please review the
following documents:
More info on
the Change and Why
Variable Structure Differences
UDBF
Definition
ICP 100
Version 3.2.5 B01 Setup EXE File
e.Con
Version 4.2.0 B07 Setup EXE File
e.con Instruction Manual
e.Console
Version 3.20 Rev 1 Setup ZIP File
e.bloxx Drivers (VB, Labview, etc.)
Drivers ZIP File
e.gate Drivers (Labview)
Labview ZIP File
|
